03-14-2001 10:48 PM - edited 03-12-2019 11:15 AM
When using the MC3810 to pipe simple digital signals (non-addressed, non-packets), using cross-connects from serial interfaces to t1's on both ends. Cannot get end devices to see eachother. Suggestions Please!
03-19-2001 07:03 AM
I think in order to solve your problem a lot of troubleshooting is needed. What exactly are you routing or bridging? What end devices cant see each other? If this is critical you might want to give TAC a call on this one.
03-22-2001 01:23 AM
Thanks, "a lot of troubleshooting" involved rechecking cable pin outs. Circuit is up and working fine.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide