Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problem wit ata's186 when upgraded to ccm 3.3.3

Hi,

I upgraded from ccm 3.2(c) to CCM 3.3.3 and right now i have som problems with my atas over the wan, the second port on the ata its not working and when i dial to other ip phone or ata from the ata i only can hear one way in the other side nobody is listening.

I try using differnets codecs but its not working any idea?

Thanx

James

1 REPLY
Silver

Re: Problem wit ata's186 when upgraded to ccm 3.3.3

Configure both ports in CallManager. They are configured as two separate devices. Just configure a second ATA device and for the MAC address take the actual MAC address, drop the first two digits and add "01" to the end. For example, if your MAC address is 0003abcd1234, then the second port would be 03abcd123401.

and check the below link for more4 information

http://www.cisco.com/en/US/products/hw/gatecont/ps514/products_configuration_example09186a00800a892f.shtml

86
Views
0
Helpful
1
Replies
CreatePlease to create content