Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
162
Views
0
Helpful
1
Replies

Problem wit ata's186 when upgraded to ccm 3.3.3

jvsaldana
Level 1
Level 1

‎01-06-2004 11:40 AM - edited ‎03-13-2019 03:13 AM

Hi,

I upgraded from ccm 3.2(c) to CCM 3.3.3 and right now i have som problems with my atas over the wan, the second port on the ata its not working and when i dial to other ip phone or ata from the ata i only can hear one way in the other side nobody is listening.

I try using differnets codecs but its not working any idea?

Thanx

James

Labels:
0 Helpful
1 Reply 1

ivillegas
Level 6
Level 6

‎01-12-2004 06:24 AM

Configure both ports in CallManager. They are configured as two separate devices. Just configure a second ATA device and for the MAC address take the actual MAC address, drop the first two digits and add "01" to the end. For example, if your MAC address is 0003abcd1234, then the second port would be 03abcd123401.

and check the below link for more4 information

http://www.cisco.com/en/US/products/hw/gatecont/ps514/products_configuration_example09186a00800a892f.shtml

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents