I am new to the Cisco support community. Sorry in advance if this post does not belong here, please feel free to move it to the correct place. We have been having some problems with some of our SPA504G and Linksys 942s phones not registering and the buttons staying in amber light. This sometimes happens when the phone is rebooted or disconnected. The setup we have is a Cisco 1841 router and a 2950 switch. Whenever the problem occurs, we apply the command "clear ip nat translations * " in the router and the phones register again, and work normally. Has this happened to anyone? We know it’s a problem with the NAT table translations, since that command does the trick. We also tried modifying the NAT translation timeout using the command “ip nat translation udp-timeout 65” but it did not work. Any ideas why this is happening, or how to fix it?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...