I'm using E&M cards on a 3640 to tie 2 pabx together across a wan link. All has been ok, until recently when I noticed a high rate of packets across the link. Troubleshooting shows the high packet rate is originating from the E&M cards, though no one is making a call. The high packet rate is causing my cpu utilisation to increase. I'm wondering if the E&M cards have gone bad or what could be responsible for the large amount of packets flow. Does any one have any ideas?.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...