Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Problem with Fax and ATA

Hi,

i do not have problem to send Fax to the PSTN, but when I try to receive a fax on the fax machine in port1 of the ATA, the machine never give fax signal.

1 REPLY
Hall of Fame Super Red

Re: Problem with Fax and ATA

Hi Leonardo,

Have a look at the following;

Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (SCCP) (2.15.ms, Rev B0)

Configuring and Debugging Fax Services

http://www.cisco.com/en/US/products/hw/gatecont/ps514/products_administration_guide_chapter09186a00800c4d1e.html#1016012

Configuring and Troubleshooting the Cisco ATA 186 with Fax

http://www.cisco.com/en/US/products/hw/gatecont/ps514/products_configuration_example09186a00800d698e.shtml

Configure Fax Detection Method on the Cisco ATA 186

Use a web browser and go to http:///dev (for example, http://172.16.104.117/dev) in order to configure the Cisco ATA 186 using the web interface.

You must configure these parameters in order to configure the Cisco ATA 186.

Audio Mode

bit 2 (18)=0 Enable detection of FAX CED (answer) tone and switch to FAX mode for the rest of the call if the tone is detected.

Hope this helps!

Rob

441
Views
0
Helpful
1
Replies
CreatePlease to create content