Based on your Directory Implementation (DC Directory is default)... I have had problems when I built a fresh Publisher when I didn't have a live ethernet connection to the Pub's NIC. FOr some reason DCD bombs out after a full install if you don't have a live ethernet connection to the server. It can just be a hub port or a switch port, but just something to make the port live on the server.
Go into DC Directory via:
Start --> Program Files --> DC Administrator
Log in with "Directory Manager" and the pw (the pw of the system". See if you can move around in it. If not then perhaps you could uninstall DCD and reinstall it. Easier to probably just reinstall if its a new install.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...