Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Cisco Support Community site will be in read only mode on Dec14, 2017 from 12:01am PST to 11:30am for standard maintenance. Sorry for the inconvenience.

New Member

problem with incoming calls

Hi,

I have got E1 trunk, CCME, I can dial-out for eternal numbers, but I cannot dial-in to internal phones, my config looks like:

card type e1 0 0

isdn switch-type primary-net5

voip-incoming translation-rule called 1

controller E1 0/0/0

pri-group timeslots 1-31

!

translation-rule 1

Rule 0 ^2232195 5

interface Serial0/0/0:15

no ip address

isdn switch-type primary-net5

isdn incoming-voice voice

no cdp enable

dial-peer voice 100 pots

destination-pattern 0T

port 0/0/0:15

dial-peer voice 10 pots

incoming called-number 223219...

direct-inward-dial

port 0/0/0:15

telephony-service

load 7912 P00307020200

max-ephones 48

max-dn 96

ip source-address 10.48.4.1 port 2000

url services http://10.48.4.2/voiceview/common/login.do

url authentication http://10.48.4.2/voiceview/authentication/authenticate.do

time-format 24

date-format dd-mm-yy

create cnf-files version-stamp 7960 Oct 13 2006 11:46:09

voicemail 2369

max-conferences 8 gain -6

dn-webedit

time-webedit

ephone-dn 1 dual-line

number 540

ephone 1

mac-address 0019.0644.5D07

button 1:1

what am I doing wrong?

also, when I am dialing-outfrom any number it is presented outside with first number... :-(

but my main question is what to do to successfully dial-in?

regards

Slawek

4 REPLIES

Re: problem with incoming calls

i had a similar problem but the experts here successfully guided me in creating a voice translational rule.

Can you let me know the number & Digits the service provider is going to forward it to you.

Narayan

New Member

Re: problem with incoming calls

My service provider is sending 9 digits, for example 223219540, internal nuber is 540 (I can see it when ISDN debug is turned on), without 0 at the beginning

regards

Slawek

New Member

Re: problem with incoming calls

I have added to telephone-service line:

dialplan-pattern 1 2233195.. extension length 3 extension-pattern 5..

and it WORKS now!

I can connect to my VoIP phones, but I cannot connect to my VIC 4FXS card...

config is like:

voice-port 0/1/0

station-id number 560

dial-peer voice 560 pots

destination-pattern 560

port 0/1/0

!

what should I add in my config ???

please help... my time is ending :-(

regards

Slawek

New Member

Re: problem with incoming calls

I think that the telco sends digits by overlap method...

Add the configuration below,

int serial0/0/0:15

isdn overlap-receving

and test!

119
Views
0
Helpful
4
Replies
CreatePlease to create content