Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Problem with Long Distance ISDN

Hi,

Does anyone here have an experience for Long Distance ISDN?

I have configure my AS5300 PRI as network side of ISDN.

But i see the Layer2 of this is not stable because T200 timer expiry.

In the cisco i din't find any command to change this parameter,

maybe somebody here can show me the way, how to solve the problem.

Regards,

Yuniarto

2 REPLIES
Bronze

Re: Problem with Long Distance ISDN

Normally when you configure a trunk that connects to the PSTN the telco will configure their side as Network and you configure your side as User. If you really need to have your side configured as Network, I would call the Telco and ask for them to change their end to User.

New Member

Re: Problem with Long Distance ISDN

My Telco side is already configure as user. Layer1 is already active

Unfortunantely when i enter show isdn status

the Layer2 state of myISDN sometimes is TIMER_RECOVERY

When i debug this event i see S8_T200 EXPIRY.

So, i think my ISDN problem caused byte T200 value which is only 1 second.

Correct me if i'm wrong with this assumption.

127
Views
0
Helpful
2
Replies
CreatePlease to create content