I am having some problems adding a "Paging" extension to a speed dial button on a Cisco 7960 phone. the phone has a 7914 attached to it which is configured and running but when I add our paging extension to a speed dial button on the phone, it doesn't show up on the phone display. It works all all our other phones that do not have a 7914. Is there a reason why this wouldn't work on this reception phone with the 7914 attached? I have CME 3.3.
It has been my experience that when adding a 7914 to a 7960, speed-dial's get put at the end of the 7914, and no longer on the phone at all. So if you wanted to put a paging speed-dial on the phone, you would need to move a few things off of the 7914 and onto the phone itself, to make room at the end of the 7914 for your speed-dials. Hope it helps.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...