After TSP upgrade from 7.0(1) to 7.0(3) i couldn't leave a message in g729 codec anymore. When I place a call to unity over WAN, I get the greeting and when asked to leave a message there is no beep ,and pressing the # does not make any difference.When I look in status monitor, i can see that unity is talking the message for 3 minutes, but the user does not even get an empty one.
I still can leave messages in g711
I tried to run sl_g729s_setup.exe but it did not make any difference.
Event Type: Information
Event Source: CiscoUnity_TSP
Event Category: None
Event ID: 103
Time: 9:03:46 AM
Cisco Unity-CM TSP device 16 (Unity port 12): G729a capable with codec version 18.104.22.168. This means that Cisco Unity will accept calls in either G.711 or G.729a format, depending on the Cisco Call Manger region settings. %4
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...