Cisco Support Community
Community Member

problems transferring a call across ITSv2

I have an ITSv2 router and an ATA186. Both are running as H323 GW. The IP phones I have connected to the ITS can transfer calls between each other freely. But call transfer fails when you try to transfer a call that is between an ATA analog phone and an IP phone. When you press transfer on the IP phone, the analog phone receives MOH as normal, but as soon as you enter the last transfer digit, the call drops at both ends. I think this may have something to do with transferring a H323 call using Skinny on the ITS. Please help...


Re: problems transferring a call across ITSv2

Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit and to open a case with one of our TAC engineers, visit

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

Community Member

Re: problems transferring a call across ITSv2

This is the same with all Analogue H323 ports. It is not supported without the use of Loopback-dn's and these are not documented

CreatePlease to create content