Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

problems with Access Gateway Module on 4506

we have a 4506 switch with Access Gateway Module and E1 PRI card on it.

I have configured the module as IP Telephony gateway and works just like an H323 IOS router. Before getting the 4506, we had a 2610 with NM-HDV-E1 card working as H323 gateway and was working fine. I have configured the Access Gateway Module the same way as my old 2610 router, but the problem is that although I can receive incoming calls fine, I can not call outgoing calls. As soon as I finish dialing the number, I get a fast busy signal.

Anyone found similar problem before?

Thanks

1 REPLY
New Member

Re: problems with Access Gateway Module on 4506

Please verify the destination pattern. It may not be configured properly.This could be one reason. And also by enabling 'debug isdn q931' you can find out the details of the call establishment.

For additional info please refer:

WS-X4604-GWY: Access Gateway Module (AGM) for Catalyst 4000 Series Switches

http://www.cisco.com/warp/public/788/products/4604_gwy.html

100
Views
0
Helpful
1
Replies