I have made each step to configure "EXTENTION MOBILITY" in the Call Manager 4.3 (Guide: Cisco Unified CallManager Features and Services Guide, Release 4.2(3) [Cisco Unified Communications Manager (CallManager)]), but my configuration in the CCM fall :(, when I try to accede to the service on the telephony IP and I ingress the username and the PIN configureds en el CALL MANAGER, and the display in the phone show "Authentication Unsucessfull", and the username and password are correct, I don't understand :( ....
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...