09-27-2002 05:57 AM - edited 03-12-2019 08:58 PM
I'm connecting one 1751 on Siemens PBX through ISDN BRI QSIG port.
The IOS is 12.2(4)YH and the problem is that the router are trying to establish a conversation in channel 0 instead 1 or 2. Then the PBX refuse the incoming call.
Is there any way to configure the router to not use the channel 0 to establish a call?
Here goes the debug q.931
1w0d: ISDN BR1/0 Q931: TX -> SETUP pd = 8 callref = 0x00CB
Bearer Capability i = 0x9090A3
Standard = CCITT
Transer Capability = 3.1kHz Audio
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA98380
Exclusive, Channel 0 <-------------- {Here happens the problem}
Calling Party Number i = 0x0183, '0713'
Plan:ISDN, Type:Unknown
Called Party Number i = 0x81, '0717'
Plan:ISDN, Type:Unknown
Sending Complete
1w0d: ISDN BR1/0 Q931: RX <- RELEASE_COMP pd = 8 callref = 0x80CB
Cause i = 0x85E418 - Invalid information element contents
1w0d: ISDN BR1/1 Q931: RX <- DISCONNECT pd = 8 callref = 0x0001
Cause i = 0x8090 - Normal call clearing
1w0d: ISDN BR1/1 Q931: TX -> RELEASE pd = 8 callref = 0x8001
Cause i = 0x8090 - Normal call clearing
10-01-2002 12:28 PM
Is there a specific reason that YH code is being used?
Try loading 12.2(11) and see if it works.
a 'debug isdn q931' will show the q931 messages where this is exchanged.
10-01-2002 12:38 PM
Because is the only version that support a NT/TE ISDN interface with QSIG signaling.
Refer to page: http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122relnt/1700/rn1700yh.htm#xtocid9
Is there any new IOS version?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide