After running the IVC install, nothing gets placed in exchange connectors nor is there anything in services. All appears to go okay and I even get a message asking if i want to start ivc. I'm running NT4 sp6a, Exch 5.5 sp4<br>I have retried a number of times with same result. Unity is 246(135)<br><br><br><br>
Make sure you've already installed the Internet Mail Service (SMTP connector) in Exchange. Make sure you're using an account that has permission to log in as a service and act as part of the OS. Are you installing on a domain controller or member server?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...