Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Problems with MGCP

Hi Community,

I´m having the following problem.

I´ve configured MGCP between Gateway and Callmanger.

Everything seems to work fine except one thing.

When I press the redial button or when I´m doing a call-setup with a CTI-Application then the call-setup fails.

In the callmanager-trace I can see the destination-number as one block and that no potential match exists.

When I´m setting up the call by typing the digits on the phone I can see in the trace the digits arriving one by one and the I´m having a match of the destination pattern.

I´m quite sure that there is only one thing I forgot to configure, but what is it?

My route-pattern is "0."

Thanks in advance for your any hint.

2 REPLIES
Community Member

Re: Problems with MGCP

I guess your Route Pattern points to a RouteList. So you just have to set the service parameter 'Enable Overlap On RouteList' to TRUE. It should work.

jp

Community Member

Re: Problems with MGCP

That´s it.

Thanks a lot !!

98
Views
10
Helpful
2
Replies
CreatePlease to create content