Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Problems with PRI ISDN with AS5300 and PBX 3Com NBX100

Hi, someone had done a connection between a controller E1 with ISDN PRI of AS5300 and a PBX 3Com model NBX750, because I did the connection and configuration but the connection don´t function. I do not find documentation about the parameters of signalling, for exmple linecode, framming, clock source, I am using HDB3, QSIG, framming CRC4, clock source internal.

Thanks,

Livio Silva

2 REPLIES
New Member

Re: Problems with PRI ISDN with AS5300 and PBX 3Com NBX100

I have noot done this, but let me guess as to what the problem probably is.

One of the two devices needs to be the network side of the connection and the other the user side. By default both sides would have been configured to eb user side. Since you have greater control on the Cisco side, make the changes to have it be the primary network. You should be able to turn on the isdn debugging and see the negotiation between the two.

Good Luck

New Member

Re: Problems with PRI ISDN with AS5300 and PBX 3Com NBX100

Yes, does rigth, I configure the AS5300 like network emulate and It function for me, the problem was the two devices were slave in the connection.

196
Views
0
Helpful
2
Replies