I have installed the software on a new W2K server in the same NT domain as my Exchange 5.5 server. I have verified that the Exchange Service account is used for the anonymous connection for the PPS website and is the account used for the Meeting Reminder Service. The problem is that when I attempt to use it, the phone "hangs" with a "Requesting..." message and then show HTTP! error and then the screen blanks and shows "Make Your Selection..." which you obviously cannot do with a blank screen.
If I look at the event log on the Exchange Server, I get event 1171 indicating an exception e00100006 with parameter 50. According to Microsoft at http://support.microsoft.com/default.aspx?scid=kb;EN-US;q271200, this means I have an LDAP_INSUFFICIENT_RIGHTS error occuring on a scheduled basis. This does not appear to have occured before PPS was installed.
Does anyone have this installed and working? I've had numerous conversations with TAC, but they simply read the manual back to me and we verify the installation and configuration. I have not spoken with anyone there who has actually installed and built a working environment. Any help would be appreciated.
You get this HTTP error if the connectivity is poor with Call Manager or if there is heavy load on PPS server. PPS should be installed on a seperate server. Is any other appication installed on the PPS server? You should not install outlook on PPS Server as cdo versions are different. Check the connectivity between CCM and PPS server. Try restarting PPS server and phones. Sometimes restarting of CCM services also helps.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...