Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Provisioning PSTN in a multi tenant building

Single site, multi tenant building running on CM4.1.3 paired with a C2821 with 4 E1 connecting to PSTN. Let just say Tenant A would only like to have 5 outbound/inbound lines to PSTN - is there any ways or methods to limit or restrict access to PSTN beyond the number of PSTN lines subscribed?

5 REPLIES
Blue

Re: Provisioning PSTN in a multi tenant building

you could use a gatekeeper to allow/disallow calls from specific users, zones, sessions and bandwidth....

no built in mechanisims in CCM to segregate channels based on user calling.

see this link for more info on gatekeepers:

http://www.cisco.com/en/US/products/sw/voicesw/ps4139/index.html

New Member

Re: Provisioning PSTN in a multi tenant building

Noted. But in order to do this, I would need another router to take the role of the gatekeeper? Am I right?

Silver

Re: Provisioning PSTN in a multi tenant building

Not really. You can run the gatekeeper function on the same router that functions as the gateway, provided you have enough hardware resources and an IOS with the feature set to support Gatekeeper functions.

Regards,

Anup

Bronze

Re: Provisioning PSTN in a multi tenant building

im not certain as to how E1 is configured, but, if you can split the group into logical ports then it should be easy by using partitions and calling search spaces. therefore, split a group into 5 slots then configure a partition and CSS for tenant A PSTN ACCESS, and assign those ppl to that css.

New Member

Re: Provisioning PSTN in a multi tenant building

Arvind & Anup,

Thanks for your feedback. Will give it a shot to see which works better.

247
Views
4
Helpful
5
Replies
CreatePlease login to create content