Is it possible to send a call to an FXS port and pull it back if no answer? I have an overhead paging system that beeps. We want to have calls roll to the paging system if the attendant does not answer, beep, and be able to pickup the call from another phone. Is this possible?
I am thinking that if the FXS port were in an MGCP gateway, you can assign that endpoint to a call pickup group. Then when it rolls to the overhead pager and beeps, you can then use pickup to accept the call.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...