Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PVDM2 on CME4 help

I have a 2801 with two PVDM2's and two VIC4-FXO installed. The 2nd PVDM was just added to the router recently. (The other was installed with the 2 FXO cards.) Since CME4 now supports remote phones on G.729 and IP Communicator, I wanted to provide some transcoding/conferencing support for them. I've added the 2nd PVDM card, its lists in "sh ver" but, when I attempt to allocate sessions, it says I have a max of "0". I think that the other FXO card has taken over the new PVDM. Is there anyway I can stop that? The 2801 only supports 2 PVDM's onboard, so I can't add another.

Can anyone provide any assistance?

Thanks,

Luke

1 REPLY
New Member

Re: PVDM2 on CME4 help

Below is the output when I do a "sh voice dsp". The voice ports listed are all on the FXO cards.

----------------------------FLEX VOICE CARD 0 ------------------------------

*DSP VOICE CHANNELS*

CURR STATE : (busy)inuse (b-out)busy out (bpend)busyout pending

LEGEND : (bad)bad (shut)shutdown (dpend)download pending

DSP DSP DSPWARE CURR BOOT PAK TX/RX

TYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABRT PACK COUNT

===== === == ========= ======= ===== ======= === == ========= == ==== ============

*DSP SIGNALING CHANNELS*

DSP DSP DSPWARE CURR BOOT PAK TX/RX

TYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABRT PACK COUNT

===== === == ========= ======= ===== ======= === == ========= == ==== ============

C5510 001 01 {flex} 8.2.0 alloc idle 0 0 0/0/0 02 0 37/0

C5510 001 02 {flex} 8.2.0 alloc idle 0 0 0/0/1 06 0 39/0

C5510 001 03 {flex} 8.2.0 alloc idle 0 0 0/0/2 10 0 39/0

C5510 001 04 {flex} 8.2.0 alloc idle 0 0 0/0/3 14 0 39/0

C5510 001 05 {flex} 8.2.0 alloc idle 0 0 0/2/0 02 0 36/0

C5510 001 06 {flex} 8.2.0 alloc idle 0 0 0/2/1 06 0 36/0

C5510 001 07 {flex} 8.2.0 alloc idle 0 0 0/2/2 10 0 37/0

C5510 001 08 {flex} 8.2.0 alloc idle 0 0 0/2/3 14 0 37/0

------------------------END OF FLEX VOICE CARD 0 ----------------------------

103
Views
0
Helpful
1
Replies
CreatePlease login to create content