Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

QCT with CCME 4.2

Dear Voice Experts

Try to configure a CCME 4.2 on a router 2821 with latest QCT version 3.0.1 cause it would reduce a lot of work for command configuring.

But always get problems that none of the included phones in QCT are compatible to CCME 4.2

Any suggestions - cause i thought workaround will be to downgrade IOS for QCT of 4.0

But that's not really an longterm solution.

Do you plan to publish a new QCT Version ???

Many thanks and greets from Vienna

Helmut Schranz

helmut.schranz@azlan.at

3 REPLIES
Bronze

Re: QCT with CCME 4.2

Upgrading to lastest version of CME 4.2. or later will help run the archive command for GUI files.

New Member

Re: QCT with CCME 4.2

Hi hadbou

I mean the combatibility of the piece of software "Quick Config Tool" for CCME what helps you to configure CCME easier.

You find the tool with the link : http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_data_sheet0900aecd802e9be9.html

Changeing the CCME version when i have to configure a piece could not be the solution ?

Thanks and greets

Helmut

Hall of Fame Super Gold

Re: QCT with CCME 4.2

Hi Helmut,

you will find that the thing that cisco does better, for sure is NOT gui / PC-based tools / etc.

These appears to be provided more to pass a "check-mark" on some tender requirements sheet, more than to be of real use.

So don't hold your breath for new improved versions, prepare solid config template and perhaps some custom text-based tool to help your repetitive configurations.

Hope this helps, please rate post if it does!

186
Views
0
Helpful
3
Replies
CreatePlease to create content