Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

QoS and bridging

Is LLQ supported if your interface is config-ed with integrated bridging and routing? Cant find any docs to support or dispute it either way. Specifically, I have applied a service-policy to a WAN interface (T1) that is bridged. It took the command, but I'm not seeing matches on my access-lists or policy-maps. Thanks in advance!

2 REPLIES
New Member

Re: QoS and bridging

A better question is why would you bridge, especially across a WAN link. I am not surprised that there are no matches on your access lists, because they are probably set for IP and the traffic is being bridged and therefore are not being processed by the policies.

Basicly, bridging across a WAN is bad, Routing across a WAN is good.

Silver

Re: QoS and bridging

You must use routing to support LLQ. Can't remember the exact reason why , but LLQ doesn't work on purely bridged interfaces.

119
Views
0
Helpful
2
Replies