Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
263
Views
0
Helpful
2
Replies

QOS for CallManager Express

ReadersUK
Level 2
Level 2

‎03-31-2006 02:57 AM - edited ‎03-13-2019 12:45 PM

HI

I have setup QoS on my LAN, however when i sniff my RTP stream from two 7912 phones i notices that they do not mark the packets with COS tag. How do i achieve this? SCCP seems to be fine but rtp is just like any other packet CoS is 0.

regards colin

Labels:
0 Helpful
2 Replies 2

timurbayazitov
Level 1
Level 1

‎03-31-2006 03:11 AM

Where is the point of sniffing ? Do you use SPAN/RSPAN feature ? Show config of the phone's switch port.

0 Helpful

ReadersUK
Level 2
Level 2
In response to timurbayazitov

‎03-31-2006 03:51 AM

Hi

I am spaning port that the phone is pluged into, below is config of phone port

interface FastEthernet0/7

switchport mode access

switchport voice vlan 2

mls qos trust cos

spanning-tree portfast

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents