Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

QoS for IP Telephony over DSL

Hi,

using the document "QoS Solutions for PPPoE and DSL Environments" as a reference I'm trying to implement Quality of Service for a DSL connection via the ATM interface on a 2821 router.

So I apply the service-policy under ATM VC configuration mode (PVC 8/35) and the command is accepted with no complaints, but when I do a show run, I realize the command is not there:

!

interface ATM0/0/0.1 point-to-point

pvc 8/35

encapsulation aal5snap

pppoe-client dial-pool-number 1

!

end

Any Idea why is this happening ?, we have version 12.3(14)T7. Is this the right way to configure QoS for DSL, or should I configure QoS on the dialer interface instead ? Any suggestions are welcome.

The document I checked can be found here.

http://www.cisco.com/en/US/tech/tk543/tk545/technologies_tech_note09186a00800b2d29.shtml

Regards.

1 REPLY

Re: QoS for IP Telephony over DSL

This link should help! Try applying it under pvc mode.

http://www.cisco.com/en/US/tech/tk39/tk824/technologies_tech_note09186a00800d76b5.shtml

Sankar

PS: please remember to rate posts!

200
Views
0
Helpful
1
Replies
CreatePlease to create content