Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

QOS Help

We have a Click to Meet (VTC) server connected to an access port on a 3560. I would like to implement QOS for the udp traffic. On the router we had the following command for QOS:

ip access-list extended VTC-PORTS

permit udp host 10.186.90.119 range 2500 2600 any

I would like to use those ranges on the switch as well. QOS is currently not configured and am hoping this only takes a few commands:)

ty

1 REPLY
Silver
120
Views
0
Helpful
1
Replies