Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

QOS Implementation

Hi

I have the below setup

CCM--- Switch--- customers Router ----IPLC circuit ---ISP Router -----Output as ethernet to the customer location .

When i install two soft phones between the two locations , without any additional configuration voice is distorted totally .

Soft PHones are present in both the network and US end soft phones are registered to the India CCM. to get a good voice quality is it enough if i implement qos on the India end router alone. Or is there any other better way since at US end customer will get out put from the local ISP as ethernet only & no configurations can be done at US end ISP side

thanx in advance

regards

Sundara Rajan .R

2 REPLIES
Silver

Re: QOS Implementation

You have to implement QOS on both ends. Implementing QOS at one end will not fullfill your requirement.

New Member

Re: QOS Implementation

Hi

I will not be able to do any changes onthe US end router . In this case i will not be able to apply the QOS policy on both ends .

Sundara Rajan .R

104
Views
0
Helpful
2
Replies
CreatePlease to create content