I am to setup some Mitel ip phones. They will be on 3524XL switches and a seperate Vlan to the data, connecting back via a 802.1q trunk to a 4006 core switch with the Mitel switch going into a port on the 4006. I have setup the ports on the 3524XL to trust the COS value so it will put the voice in the higher of the switches two queues, however the 4006 end confuses me, the voice traffic will be staying within layer2 ports ie either between 802.1q trunks or to the layer2 port that the Mitel switch is on, so do i need to convert the COS to DSCP and configure policies and policing and priorities on the 4 queues on the 4006 ?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.