The PA-A2 does not support LLQ( CBWFQ). Does anyone know if there is any other way I can prioritise my Voice traffic to guarantee the quality for my users when using this module. ( I cannot swap out to a PA-A3 as I am using the Circuit Emulation Ports at the moment.)
Since you are doing CES and the port looks just like a T1, that is what it will act like, a T1. Since there is no queueing on a T1, there is no queueing in CES, it is all FIFO. Whatever device is connected to the port will have to do the queueing on the packets it want to send on the emulated circuit (just like a regular T1)
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...