Has anyone had experience configuring QoS on the EtherSwitch Modules on the ISR routers? Auto QoS Voip is limited in this environment (as of 12.4(7b) at least) and does not support (that I can find) the "cisco-phone" extension to extend trust if a Cisco IP Phone is detected via CDP.
I don't like the idea of using the "trust" keyword here, as it opens things up too much, so the only real alternative I see is to use classes and policies on the VLAN interface for voice to mark the packets as they come in from the phone. Anyone have a better suggestion? Any Cisco insiders know if the "cisco-phone" extension is coming soon to an IOS near us?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.