I have a link with 2 MB and I have 2 application groups. One group are application that can use all link BW (2mb) and I have other app that runn over tftp protocol; If the first app group use 1.8 MB, this ftp application can use 0.2 MB, if first group app use 1.5 MB, ftp aplication will use 0.5 MB, and if the first group app use only 0.5 MB, the FTP application can use maximum 1 MB. The purpose is that first group application can runn without BW problems. How can Implement it?
You can reserve a strict priority of 1.8 Mbps for the first application group using a seperate class map matching that application and another class map matching second application group with a maximum bandwidth gurantee of either 1Mbps or 500Kbps for the same.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...