I have a Cat 4003 and a Cat 5505 that I must connect PBX lan cards into. The PBXs will mark their voice and control packets with the appropriate TOS/COS/DSCP bits (we set them to mark DSCP values and COS values). I need the 4003 and 5505 to TRUST these values and pass them thru unchanged - and also apply some priority queueing if possible.
Here is a quick break down of the 4003 and 5505:
- Sup I (WS-X4012) ver. 6.4(6) bootstrap=5.4(1)
- 48-port (WS-X4148-RJ45)
- SUP III (WS-F5521)
- NFFC (WS-F5521)
- Uplink (WS-5530)
- RSM (WS-X5302) IOS-12.1(19)
- 24-port (WS-X5236)
1. Will the 4003 & 5505 with the above modules trust the TOS bits?
2. What version of CatOS should I upgrade to to get the best QOS results?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...