Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

QSIG , CCM, H323 gateway and Calling name

1.- What version of CCM should I use to pass "Calling name" through a PRI QSIG H323 Gateway ?

2.- What version of 2651 IOS should I use?

3. What IE the gateway is using to pass the Calling Name?

4. What are the facilities that this configuration support?

1 REPLY
Cisco Employee

Re: QSIG , CCM, H323 gateway and Calling name

1- 3.3(2c)

2- 12.2(15)T2

3- In the Setup IE

Cisco CallManager supports the following aspects of the QSIG protocol: QSIG basic call, direct dialing inward, certain supplementary services (name identification services), and certain QSIG generic functions services for support of supplementary services (call-related procedures for transport of application protocol data units and connection-oriented, call-independent application protocol data units). For information on whether your gateway supports the QSIG protocol, refer to the gateway product documentation.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/prod_release_note09186a008011e2c8.html#1344646

265
Views
0
Helpful
1
Replies
CreatePlease login to create content