Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

QSIG Interoperability with Bosch 33XE

Hi,

I need to interconnect a cisco 2811 voice gateway in MGCP/QSIG (and CallManager 4.2) with a bosch 33XE PBX version E06.

Does someone have a feedback on what is supported in this configuration (path replacement, name display, ...) ?

Thanx,

Bastien

1 REPLY
New Member

Re: QSIG Interoperability with Bosch 33XE

CCM 4.2 has a fully-featured implementation of QSIG. I'm not familiar with the Bosch PBX at all, but you should be fine as long as it supports the features you require.

Here's a link to the CCM System Guide explaining the QSIG features supported in CallManager:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00803edb19.html#wp1139777

HTH,

John

187
Views
0
Helpful
1
Replies