Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

QSIG MGCP INTREGATION with MD110

Hi everybody, i have done a qsig MGCP integration with an MD110.

Everything works fine, but my problem begins when other PBX that are integrated too with MD110 don't arrive my calls (an ALCATEL with a qsig trunk against the ericsson MD110).

I trace the qsig q931 of my voicegateway.

Can anybody help me about.

In the attachmen you can see a call originated in my CCM 6.1 and the destination called is an extension through this alcatel-PBX.

An puts me the next statement:

*Sep 5 11:05:41.159: ISDN Se0/0/0:15 Q931: RX <- DISCONNECT pd = 8 callref = 0

x8033

Cause i = 0x81E5 - Message not compatible with call state

The calls between the CCM 6.1 and the MD110 works right!!

Thanks in advance

2 REPLIES
New Member

Re: QSIG MGCP INTREGATION with MD110

What version of the MD110 software are you running? What does the route data look like for the trunk going to the CCM and the Alcatel look like? (I believe the command is RODAP; if you are in command line mode on the Ericsson, but can't remember for sure.)

Thx,

Steve

New Member

Re: QSIG MGCP INTREGATION with MD110

Hi Earphoria,

Which version is the MD110 and did you get the name &n umber to pass from Ericsson to Cisco? If so, could you please send me docs. on how to set that up? Thanks...

249
Views
0
Helpful
2
Replies