Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Question from a non MCSE about permissions when installing Unity/Exchange

I get this message when running the message store config wizard. Exchange is offbox and Unity version is 4.0(3)

"You do not have sufficient rights to verify specified users password"

This happens at the point where I enter the password for the directory services account.

Please help!!

Thanks,

1 REPLY
Cisco Employee

Re: Question from a non MCSE about permissions when installing U

Are you logged into the box as the same account you configured as the install account in the permissions wizard at the start of the installation (i.e. before the reboot)? It sounds like the account you're logged in as doesn't have the rights the permissions wizard would have assigned to it.

You can review the permissions/accont setup information in the 4.0(3) install guide here:

http://www.cisco.com/en/US/products/sw/voicesw/ps2237/products_installation_guide_chapter09186a00801ba4d6.html

If you get in a jam you can just be sure you're logged in as an account that's a member of the domain admins group when you run this which will ensure you have the rights to check PW settings.

82
Views
0
Helpful
1
Replies
CreatePlease login to create content