Couple more:<br><br>If I wanted to change the LDAP port used by Exchange, would I go to Exchange Administrator, Site, Protocols or Echange Administrator, Server, Protocols?<br><br>2nd: When I install Unity, should I set circular logging to off, in Exchange. <br><br>
1. I normally reccomend changing the LDAP port at the site level and making sure the server is using the site defaults if you can. We've seen a couple cases where leaving the site at 389 and changing a server in that site to, say, 1024 has problems. Should work either way technically. A reboot after making the change is a good idea as well.
2. If you're doing regular tape backups using Veritas, for instance, you'll want to have circular logging off so you can do delta backups through the week and a full backup on the weekends or something. If you're not doing regular backups (bad administrator, no doughnut) then you'll want circular logging on so the transaction logs don't fill up the hard drive.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...