"Conversation" between ATA IP phone adaptor and voice gateway
i have installed in our network the new ATA 180 analog telephone adaptors. Between 2 ATA everything is working (i can speak one hour if i want ), but if i call one voice gateway from our network, after 2 minutes the conversation are disconnected (the ATAs registering without problems with our gatekeeper )
Re: "Conversation" between ATA IP phone adaptor and voice gatewa
It needs to be debugged to see who is disconnecting the call.Possibilities:1) Is the GK sending a DRQ for the call2) The GW may/may not be receiving some RTP/RTCP messages?3) Disconnect from the PSTN side of the GW?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...