Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

"Host Not Found" after selecting Login service

Users are getting a "Host Not Found" message when they select the Login service

3 REPLIES

Re: "Host Not Found" after selecting Login service

Are you using DNS name or ip address under server config page in CM>

Under Enterprise parameters in CM, you should set URL services to use an ipaddress rather than name (unless you have DNS set up for the phones)

Also check if the Login IP Phone services uses an ip address rather than DNS name.

HTH

Sankar.

New Member

Re: "Host Not Found" after selecting Login service

I have IP addresses in both those locations.

Re: "Host Not Found" after selecting Login service

What is this service for ? Can you paste the URL ?

161
Views
0
Helpful
3
Replies
CreatePlease login to create content