Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

"no h225 timeout keepalive" and h323 preserve

Hi, Here is the scenario. A single site IPT where gw is using h323. If I have "no h225 timeout keepalive" configured in h323 gw, an acive call is established between pstn and ip phone, if ccm fails, will the call still preserved? thanks

1 REPLY
New Member

Re: "no h225 timeout keepalive" and h323 preserve

You need to perform a few extra steps:

On the router,

voice service voip

h323

call preserve

then on the call manager (in my case 4.1)

Service -> service parameters -> advanced

Then under H323 set "Allow peer to preserve H323 calls"

After doing all of that try a test call and block access to the CCM via an ACL - phone should display "CM Down, features disabled" but the RTP stream should continue between the phone and router.

2438
Views
0
Helpful
1
Replies