I've a customer that needs the above announcement before sending the call to the DDI numbers. The extensions are being recorded by Witness Systems.
They only have CallManager and Unity.
I was looking at doing this in Unity by sending call to a call handler based on it's DDI in the Unity routing table. This would be forwarded on to a Call Handler specific to the DDI with the announcement then another Call Handler to transfer to the actual extension.
1. What's the maximum amount of entries in the forwarding routing table?
2. If the subscriber already exists with the same DDI number the call is sent to the subscribers call handler instead.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.