05-23-2002 11:15 AM - edited 03-12-2019 06:57 PM
I have a cisco AS5300 gateway and I would like to use acs to do accounting, how I configure the acs in order to bill the calls that I recieve from other carriers, Do I have to assign each carrier a user ? How I do it? Please is vital for me to solve this problem
05-23-2002 09:39 PM
Typically, you can enable the as5300 to send accounting records to your radius server by issuing
! Enable New AAA model
! Enable AAA Accounting
!
aaa new-model
aaa accounting connection h323 stop-only group radius
!
! RADIUS
!
radius-server host xxx.xxx.xxx.xxx auth-port 1812 acct-port 1813 key 7 xxxxxx
radius-server retransmit 3
radius-server attribute nas-port format c
radius-server vsa send accounting
!
! Enable Accounting
!
gw-accounting h323 vsa
gw-accounting voip
!
!
This will send all stop records to your radius server.
You can additionally set up a very simple radius server using freeBSD, (http://www.freebsd.org) and a program like cistron-radius (http://www.radius.cistron.nl/).
There are multiple ways to tell carriers apart, and properly bill them for the traffic they sent. It took me about 6 months to write the software to do this properly.
Then again, you can always purchase some commercial products that do this.
Arkady Sorokin
VoIP Engineer
Nextcarrier inc.
06-07-2002 04:06 AM
Please check in cisco Site
there are lot of sample configuration given
best of luck
hari
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: