I have a 7835HP with a mirrored array. I noticed a blinking red light(trash can with X) on the drive. I checked the hp array tool and there are no errors with the array or the drive. I then hot swapped a new drive in the array to replace the suspect bad drive, the array mirrored the drived but then the same light is now flashing on the new drive. anyone seen this before, is this an indication of a controller going bad? did a search on cisco and cant seen to find documentation for the hard drive lights.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...