I have a 7835HP with a mirrored array. I noticed a blinking red light(trash can with X) on the drive. I checked the hp array tool and there are no errors with the array or the drive. I then hot swapped a new drive in the array to replace the suspect bad drive, the array mirrored the drived but then the same light is now flashing on the new drive. anyone seen this before, is this an indication of a controller going bad? did a search on cisco and cant seen to find documentation for the hard drive lights.
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...