I have an application which pushes Caller information to the IP Phone when the there's an incoming call. However, this takes away the "Answer" softkey. How can I re-create the answer softkey? I have done quite a bit of research, but I haven't been able to come up with a solution. Any help would be very appreciated.
sure. In your CiscoIPPhoneText object (is that what you're pushing the info to the screen with?) create a SoftKeyItem, set its Name to 'Answer' and the URL to 'Key:Speaker'. This will do the same as the standard 'Answer' soft key.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.