Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

RE : Low Bandwidth for internal calls?

Dear sir,

Please advise why when we make internal call, the phone panel show "low bandwidth" ? We have 1 Pub and 2 sub in the structure.

1 REPLY

Re: RE : Low Bandwidth for internal calls?

What version of CallManager are you running including service packs? Basically you

receive a "Bandwidth" message if you have run out of available bandwidth configured for

your location. Go to System > Location to determine the available bandwidth allowed

for calls from other locations to this device's location. You can check a device's

location by going to Device > Phone. AAR can also be configured in your voice network

if you are running Version 3.3.3 and later. AAR allows the call to be re-routed over the

PSTN if there is no available bandwidth.

171
Views
0
Helpful
1
Replies