Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Read-Only FastDials

Hello,

I would like to setup a "System Speed Dial" FastDial service. Is there any way to make it read-only from the phones? I'm passing the full URL for the IP Phone Service including userID/PIN. This way users simply subscribe to a service without needing to enter a userID/PIN.

Any tips would be much appreciated!

Regards,

Josh Miller

1 REPLY
Bronze

Re: Read-Only FastDials

You can go through the following URL for any help regarding the setup of fast dial:

http://www.cisco.com/en/US/products/hw/phones/ps379/products_configuration_guide_chapter09186a00800adf19.html#31301.

This gives a step-by-step procedure on how to setup fast dial service.

105
Views
0
Helpful
1
Replies
CreatePlease to create content