Reading the Facility Callername from a tcl script

[kevinbadeen]

I am looking for a way to read the Callingname in the facility message so that I can pass into

set callInfo(displayInfo)

Basically I'm trying to pass Callername to an ip phone through a TCL script on the gateway during callsetup. This normally gets dropped.

Is there a way to parse these fields in the Facility message?

Thanks ahead of time for any help.

Oct 14 21:59:58.274: ISDN Se0/0/0:23 Q931: RX <- FACILITY pd = 8 callref = 0x03BB

Facility i = 0x9F8B0100A117020101020100800F5452494F4E20574F524C44204E4554

Protocol Profile = Networking Extensions

0xA117020101020100800F5452494F4E20574F524C44204E4554

Component = Invoke component

Invoke Id = 1

Operation = CallingName

Name Presentation Allowed Extended

Name = MY CALLINGNAME

[paolo bevilacqua]

Is the person that rated my post above as "1" willng to explain why ?

Because what I wrote is 100% correct and verified, and I challenge you to prove otherwise.