I have a pri with 12 incoming lines. These phone #'s aren't in any particular sequence as they have been added over the years and too established to change easily. I want all 12 lines inbound to terminate on the receptionists phone (ext 200). I want all incoming lines to ring on button 1 in an overlay type scenario.
Would this config work?
voice translation-rule 10
rule 1 /5551111/ /200/
rule 2 /5552222/ /200/
rule 3 /5553333/ /200/
rule 4 /5554444/ /200/
rule 5 /5555555/ /200/
rule 6 /5556666/ /200/
voice translation-profile PSTN_TO_RECEPTION
translate called 10
dial-peer voice 1 pots
incoming called-number 200
translation-profile incoming PSTN_TO_RECEPTION
ephone-dn 1 dual-line
call-forward busy 771
call-forward noan 771 timeout 10
type 7960 addon 1 7914 2 7914
would this work as intended or would i need to break out each individual line into a seperate translation rule, insert each one into a seperate ephone-dn, the use the button 1oxxx overlay commands?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...